Westermo TD-23 Installationshandbuch PDF herunterladen (Seite 36)

36 6178-2203

S-registers

Below follows a description of the S-registers and its different components. Note that

some parameters can not be changed due to local PTT-regulations in different countries.

Where nothing else is stated the registers are stored by using the AT&W command. Some

registers are read only registers and can not be changed from the DTE.

Values inside {..} describes the valid interval and the unit is written inside parenthesis ().

S0 – Number of Rings to Auto-Answer

Sets the number of the rings required before the modem automatically answers a call. Zero disables

auto-answer mode.

Default 2 {0..255} Affected by country setting.

Please also refer to S1

S1 – Ring Counter (Read only register)

Incremented each time the modem detects a ring signal. Cleared if no rings occur after a short period

of time.

Please also refer to S0.

S2 – Escape Character

S2 holds the decimal value of the ASCII character used as the escape character. The default value

corresponds to an ASCII ‘+’. A value over 127 disables the escape process, i.e.; no escape character

will be recognised.

Default 43 (+) {0..255} (ASCII decimal).

Please also refer to S12, ATO.

S3 – Carriage Return Character (Not stored with the AT&W command!)

Sets the command line and result code terminator character.

Default 13 (CR) {0..127} (ASCII decimal).

Please also refer to S4.

S4 – Line Feed Character (Not stored with the AT&W command!)

Sets the character recognised as a line feed.

Default 10 (LF) {0..127} (ASCII decimal).

Please also refer to S3.

S5 – Backspace Character (Not stored with the AT&W command!)

Sets the character recognised as a backspace. The modem will not recognise the Backspace character

if it is set to a value that is greater than 32.

Default 8 (BS) {0..32} (ASCII decimal).

S6 – Wait Time for Dial Tone

Sets the length of time, in seconds, that the modem will wait before starting to dial after going off-

hook when blind dialling.

Default 3 {0..255} (seconds). Affected by country setting.

S7 – Wait Time For Carrier After Dial

Sets the length of time, in seconds, that the modem will wait for carrier before hanging up.

Default 50 {1-255} (seconds). Affected by country setting.

S8 – Pause Time For Dial Delay

Sets the time, in seconds, that the modem must pause when the ”,” dial modifier is encountered in the

dial string.

Default 2 {0-255} (seconds).

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

Kommentare zu diesen Handbüchern

Keine Kommentare

Westermo TD-23 Installationshandbuch Seite 36

Kommentare zu diesen Handbüchern